Free consultation hotline:139-2551-3728
customer service email:xiongdagooseneck@foxmail.com
【Headset Cable】

【Headset Cable】

Manufacturer : 
Dongguan,Guangdong
Fastest delivery : 
3 Day
Processing : 
Personalized customization.
Applicable scope : 
Medical, mechanical, aviation, home, etc.
Pro Brand : 
Xiongsen
Minimum purchase : 
50 units.
Abstract introduction: The microphone snake hose is an important connecting component consisting of a flexible tube, mesh sleeve, and joint. The metal hose has the characteristics of good elasticity and small stiffness. The mesh sleeve of the metal hose is made of stainless steel wire (stainless steel strip), which……
  • Introduction
【Headset Cable】

The microphone snake hose is an important connecting component consisting of a flexible tube, mesh sleeve, and joint. The metal hose has the characteristics of good elasticity and small stiffness. The mesh sleeve of the metal hose is made of stainless steel wire (stainless steel strip), which not only increases the pressure of the metal hose but also protects the bellows. The metal hose has various forms of joints that can be selected according to the actual situation of the project. There are many types of metal hoses, and clients can make choices according to their actual situations.

1. The microphone gooseneck tube is a type of metal hose. The end face of the pipe should be flat. After the produced pipe is polished with a grinding wheel or other tools to remove burrs, it should be cleaned with high-pressure air before use.

2. When pre-installing pipe joints, try to keep the pipe and joint body in the same coaxial position. If the deviation of the hardware hose is too large, it will also cause seal failure. The pre-installation force should not be too large, and the sleeve edge should be just embedded in the outer wall of the pipe. The clamping sleeve should not have any obvious deformation. Gooseneck tubes, desk lamp hoses, LED hoses, and metal hoses should be assembled with the specified tightening force. The tightening force of the ф6-1 clamping sleeve is 64-1 15n, the tightening force of the 16фmmR is 259n, and the tightening force of the ф18mm is 450n. If the clamping sleeve is seriously deformed during the pre-installation process, the sealing effect will be lost. When connecting pipes, the pipes should have sufficient deformation margin to avoid being subjected to tensile force. When connecting pipes, the lateral force should be avoided. If the lateral force is too large, the seal will not be tight.

3. To prevent pipe joints from leaking in hydraulic systems, both metal pipe joints and hose joints are prone to leakage. For clamping sleeve pipe joints, due to the larger external force or impact on the pipe, the sleeve may loosen or the pipe end face may deform. At this time, check whether the sleeve is out of round, whether the blade is damaged, whether the pipe end is intact, the tightening degree of the clamping sleeve nut, and also eliminate the external force on the pipe.

Advantages of the microphone hose:

1. The hardware hose has flexible spacing;

2. The hardware hose has good flexibility, no blockage, and is easy to thread and locate;

3. The hardware hose has good consistency in diameter;

4. The hardware hose is soft, can be repeatedly bent, corrosion-resistant, and high-temperature resistant;

5. The hardware hose is resistant to rodent bites, has good wear resistance, and prevents internal wire wear;

6. The hardware hose is resistant to bending, stretching, and lateral pressure.

 

Previous:【Gooseneck Microphone】 Translate the above content into English. Next:"Window intercom microphone hose."